RIFLECX Cermic Grease for Threads - 100 g

Why do I need KERAMIC GREASE from RifleCX?

A large number of shooters do not unscrew the compensator or silencer (especially with AR-type rifles), and do not pay attention to the thread at the end of the barrel or its tip… Eventually, the moment comes when we want to clean the compensator or silencer well, so we start unscrewing it and… plop, a burnt 'amen'. In extreme situations, we are left with heating it with a torch.

To avoid burning and damaging the thread and crown of the barrel, it is enough to unscrew the compensator after each shooting, remove dirt from the thread and crown of the barrel with RIFLECX PISTOL CLEANER (in this case, we recommend using a brass brush) and then use the permanent KERAMIC GREASE from RifleCX so you can shoot later without stress. A similar procedure can be used for choke tubes in shotguns – if you lubricate the choke with grease before shooting, you will find it easier to disassemble. KERAMIC GREASE from RifleCX is excellent for firearms using black powder.

KERAMIC GREASE from RifleCX is resistant to extremely high temperatures. So it doesn't matter if you are shooting X cartridges during practice or are lucky enough to have 'full auto' - it will always protect against water and burns. It adheres perfectly to the surface and prevents sticking. CERAMIC GREASE from RifleCX is an alternative to GRAPHITE SPRAY from RifleCX – for users who prefer solid grease.

USE:

After cleaning the thread, apply the grease to the surface.

SPECIFICATIONS:

Resistant to high temperatures – up to 1400°C. High grease plasticity at low temperatures, confirmed by test results from the Technical Institute of the Air Force.

Capacity: 100g.

Waterproof, hydrophobic.